banner

Dr. Ernest Markose Mathew

Dr. Ernest Markose Mathew
Associate Professor
Qualifications:
  • B.Tech, Mechanical Engineering, Mahatma Gandhi University, 1992
  • M.Tech, Mechanical Engineering, Mysore University, 1994
  • Ph.D., Mechanical Engineering, MG University, Kottayam, 2021
ernest@mace.ac.in

  • Machine Design
  • Solar Energy
  • Engineering Management

  • Soni Kuriakose, Georgekutty S Mangalathu, Biju Cherian Abraham, Sunny K George, , Ernest Markose Mathew (2021).” Nano Particle Additive to Plastic Biofuel”. International Research Journal of Engineering and Technology. Volume: 08, Issue: 07
  • Soni Kuriakose, Biju Cherian Abraham, Georgekutty S Mangalathu, Sunny K George, Ernest Markose Mathew (2021).” Prospective of Chicken Fat Biodiesel as a fuel for Diesel Engines”. International Research Journal of Engineering and Technology. Volume: 08 Issue: 07
  • Krishnanunni, S., Paul, J., Potti, M., & Mathew, E. M. (2012). Evaluation of heat losses in fire tube boiler. International Journal of Emerging Technology and Advanced Engineering, 2(12), 301-305.
  • Kurian, A. M., Yeldose, D. B. C., & Mathew, E. M. (2014). Effect of Wire EDM Parameters on Surface Roughness of Stainless Steel 15-5 PH. International Journal of Engineering and Innovative Technology, 4, 87-90.
  • Shans, M. S., & Mathew, E. (2015). Hydrodynamic study of four duct swirling fluidized bed and the effect of air temperature on fluidization. International Journal of Science, Engineering and Technology Research, 4, 3618-3623.
  • Binu, T. S., & Mathew, E. M. (2015). Effect of plenum chamber depth of a four duct plenum chamber in a swirling fluidized bed. Int. J. Sci. Eng. Technol. Res., 4(10), 3601-3610.
  • Nazar, S., & Mathew, E. M. Effect of number of slit rows in a distributor plate of a four duct plenum chamber in a swirling fluidized bed.
  • Jose, J., Mathews, R., & Mathew, E. M. (2015). Computational analysis and simulation of thermo-electric power generation from automotive exhaust gas. International Journal of Engineering Research and General Science, 3(5).
  • Daniels, R. K., Babu, N., Jacob, B., Issac, J. M., & Mathew, E. M. (2017). Design, Fabrication and Calibration of a Five Hole Pressure Probe for Measurement of Three Dimensional Flows. Global Journal and Development Journal for Engineering, 2(5), 102-114.

  • Life Member ISTE
  • Life Member KMA